TPS63002DRCT - Texas Instruments

Comentarios de los clientes

Evaluación: 10 Artículos

• Mark***

  14/10/2026

  We were restoring an automotive control board that uses this Infineon microcontroller. The replacement programmed successfully and communication with the other modules was restored. The repair took some patience, but the component did its job.

• OldS***olLogic

  08/10/2026

  The CPLD itself works as expected and programmed correctly with our existing setup. It is an older device, so getting the development environment ready took some time, but the hardware has been dependable.

• Moto***bRavi

  28/09/2026

  This DSP was needed for a legacy motor controller. Programming worked on the first board and speed regulation is operating normally again. Very useful for keeping older equipment running.

• ECUb***h

  22/09/2026

  Used for repair of an older automotive ECU. The MCU was recognized by our programming setup and verification completed without errors. The repaired board now starts and communicates normally.

• RS48***ieldTech

  16/09/2026

  Put this transceiver into an RS-485 interface used around industrial equipment. Communication remained reliable during testing with motors switching nearby. Good result for the replacement board.

• Logi***b_Chris

  08/09/2026

  Purchased for a Cyclone III development project. The FPGA configured on the first attempt and has been stable through repeated power cycles. No problems with the I/O we are using.

• Circ***FixerTom

  02/09/2026

  Used this rectifier in a high-current power supply repair. Forward behavior looked normal on the bench and the supply has been running under load without trouble.

• Retr***UWorks

  31/08/2026

  Needed the exact ST10F269Z2Q6 for servicing an older control unit. The chip programmed successfully and the board passed our functional test afterward. Much easier than redesigning around a newer MCU.

• Andr***PCBLab

  28/08/2026

  I needed this ADC for an older data acquisition board. Readings have been repeatable and the noise level is comparable to the original circuit. Happy with the purchase.

• Leat***O'Keefe

  20/08/2026

  one of my hobbies is skydiving. and when i'm skydiving this works great.

Escribe una reseña

Su dirección de correo electrónico no se publicará.